Compatible And Related Netgear Products; System Requirements - NETGEAR WG102 Reference Manual

Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point
The wireless access point incorporates Auto Uplink
automatically sense whether the Ethernet cable plugged into the port should have a 'normal'
connection such as to a computer or an 'uplink' connection such as to a switch or hub. That port
will then configure itself to the correct configuration. This feature also eliminates any concerns
about crossover cables, as Auto Uplink will accommodate either type of cable to make the right
connection.

Compatible and Related NETGEAR Products

For a list of compatible products from other manufacturers, see the Wireless Ethernet
Compatibility Alliance Web site (WECA, see http://www.wi-fi.net).
The following NETGEAR products work with the WG102 Access Point:
• WAG511 a/b/g 108 Mbps Dual Band Wireless PC Card Adapter
• WAG311 802.11a/g 54 Mbps Wireless PCI Card
• WG311T 802.11g 108 Mbps Wireless PCI Card
• WG311 802.11g 54 Mbps Wireless PCI Card
• WG511T 802.11g 108 Mbps Wireless CardBus Adapter
• WG511 802.11g 54 Mbps Wireless CardBus Adapter
• WG111 801.11g 54 Mbps Wireless Bridge

System Requirements

Before installing the WG102, make sure your system meets these requirements:
• A 10/100 Mbps Local Area Network device such as a hub or switch
• The Category 5 UTP straight through Ethernet cable with RJ-45 connector included in the
package, or one like it
• A 100-240 V, 50-60 HZ AC power source
• A Web browser for configuration such as Microsoft Internet Explorer 6.0 or above, or
Netscape Navigator 4.78 or above
• At least one computer with the TCP/IP protocol installed
• 802.11g or 802.11b-compliant devices, such as the NETGEAR WG511 Wireless Adapter
2-4
technology. The Ethernet port will
TM
October 2004
Introduction