Default Factory Settings - NETGEAR WG102 Reference Manual

Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point

Default Factory Settings

When you first receive your WG102, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see
"WG102 front panel" on page
User Name (case sensitive)
Password (case sensitive)
Network Name (SSID)
Broadcast Network Name (SSID
802.11g Radio Frequency Channel
Restricting connectivity based on MAC
Time Zone Adjust for Daylight Saving TIme
3-3
2-6.
FEATURE
Operating Mode
Access Point Name
Built-in DHCP client
IP Configuration
WEP/WPA
Access Control List
Time Zone
SNMP
October 2004
FACTORY DEFAULT SETTINGS
admin
password
Access Point
netgearxxxxxx where xxxxxx are the last six digits
of the wireless access point's MAC address
DHCP client disabled, it uses the default IP address
IP Address: 192.168.0.229
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
NETGEAR
Enabled
11
Disabled
Disabled
GMT
Disabled
Disabled
Basic Installation and Configuration