NETGEAR WAB102 User Manual page 20

User's Guide for the WAB102 802.11a+b Dual Band Wireless Access Point
TCP/IP Configuration Parameters
CONFIGURATION
Access Point Name
IP Address
Subnet mask
Default gateway
DHCP Client
If the WAB102 cannot locate a DHCP server upon powering up, it will default to
the IP address of 192.168.0.226. If you are not sure of the IP address of the
WAB102, restore the default IP address by pressing the Restore to Factory
Default button located on the WAB102 back panel for at least 5 seconds. The
WAB102 will pass the IP address from the DHCP server to the associated station
if the DHCP client is enabled.
Setting Up Basic Wireless Connectivity
DESCRIPTION
The unique name represents the access point.
The default Access Point Name is located on
the bottom label of WAB102. You may modify
the default name with a unique name up to 15
characters long.
Default: netgearxxxxxx, where xxxxxxx
represents the last 6 digits of the WAB102 MAC
address.
Specifies the IP address of the access point.
Default: 192.168.0.226
Specifies the subnet mask of the access point.
Default: 255.255.255.0
Specifies the default gateway IP address.
Default: 0.0.0.0
The access point will get the IP address, subnet
mask and the default gateway automatically
from the DHCP server if the DHCP is enabled.
Default: Enable
17