NETGEAR RH348 Reference Manual page 67

Table 5-2. Fields in Menu 11.2 - Remote Node PPP Options
Field
Encapsulation
Compression
Multiple Link Options:
BOD Calculation
Base Trans Rate
Max Trans Rate
Target Utility
Add Persist
Subtract Persist
Remote Node Configuration
Reference Guide for the Model RT328 and Model RH348 ISDN Routers
Description
Select CCP (Compression Control Protocol) for the PPP or MP link. Two options
are available in this field:
• Standard PPP—Standard PPP options are used (default).
• CISCO PPP—Cisco Systems PPP options are used.
Allows the negotiation of data compression with the remote node router.
Select the direction of the traffic you want to calculate in order to determine when
to add or subtract a link. The default for this field is Transmit or Receive.
Select the base data transfer rate for this remote node. This parameter is in
kilobits per second (Kbps). Two options are available for this field:
• 64—Only one channel will be used (default).
• 128—Two channels will be used when a packet triggers a call.
Enter the maximum data transfer rate allowed for this remote node. This
parameter is in kilobits per second. There are two options for this field:
• 64—At most, one channel can be used (default).
• 128—A maximum of two channels can be used.
Enter the two thresholds separated by a hyphen ( - ) for subtracting and adding
the second channel. The default is 32-48.
This parameter specifies the number of seconds that traffic must be above the
adding threshold before the router brings up the second channel. The default is
5 seconds.
This parameter specifies the number of seconds that traffic must be below the
subtraction threshold before the router drops the second channel. The default is
5 seconds.
5-5