Korg MR-1 Easy Start page 3
Hide thumbs
Also See for MR-1:
- User manual (16 pages) ,
- Owner's manual (56 pages) ,
- System update (2 pages)
Advertisement
Manually adjust the input gain:
1.
Press the REC button, and then press the MENU button > REC LEVEL. The screen will indicate Input Gain: Stereo/Indiv./Auto.
2.
Press the P‐DIAL to make the selection field active and then rotate it to select Stereo if it is not already selected..
3.
Press the P‐DIAL to exit from that field, and rotate it to select InL gain (left).
4.
Press and then rotate the P‐DIAL to set the desired input gain. Notice that both inputs adjust to the same value.
5.
Start recording from record ready mode, by pressing the PLAY button. If needed, pressing the P‐DIAL during recording will take you
back to the REC LEVEL screen to adjust levels further.
6.
When finished recording, press the STOP button.
Note:
Pressing STOP will close the current file, and pressing REC again create a new file. If you want to interrupt recording and not create a
new file, press the PLAY/PAUSE button.
Note:
If you wish to use the Auto Gain function instead of manually‐setting your record levels, refer to page 19 in the Owner's Manual
for more information.
R
e
c
o
r
d
i
n
g
o
n
t
h
e
M
R
‐
1
R
e
c
o
r
d
i
n
g
o
n
t
h
e
M
R
‐
1
Recording using the line inputs:
If you're recording from a device whose line output level is low (consumer level), set the GAIN switch to high (H).
If you're recording from a high level (professional) source, set the GAIN switch to low (L).
You can use balanced or unbalanced ¼" phone jacks to make connections.
Note:
If the level is too low even when the input level L/R knob is turned up, set the GAIN switch to the H position.
Recording using the mic inputs:
Use the XLR connectors to make connections.
Note:
The XLR inputs always go through the mic pres – do not use them to connect a line‐level balanced input to the MR‐1000, use the TRS ¼"
connectors. These do not go through the onboard mic pres. This is also how you would connect an external mic pre if desired.
If you need phantom power for your condenser mic, set the phantom power switch (48V) located on the back panel to the ON position. Make sure
that your microphone is already connected BEFORE you turn phantom power on!
Selecting the recording format:
Select the recording format by pressing the MENU button > REC MODE > NEW Project Type.
Note:
Refer to page 36 in the Owner's Manual for more information on project formats.
Adjusting the recording level:
1.
Press the REC button to enter record‐ready mode. The LED will blink.
2.
While watching the level meter screen, use the recording level L and R knobs to set the level as high as possible without allowing the signal
to clip when the volume is loudest.
0
0
0
0
0
0
3
MR-1 / MR-1000 EasyStart
Advertisement
