Advertisement
3.
Remove the screw G attaching the power amplifier
board on the back of the body. Disconnect the wire
from connector CN301 and pull the power amplifier
board fully outward.
4.
Raise the right and left door arms by turning the gear
a in the rear of the power amplifier board.
5.
After the CD mechanism base assembly is detached
from the door arms, pull the CD mechanism base
assembly toward the front and disconnect the wire
from connector CN804 on the left side of the door
arm board.
6.
Pull out the CD mechanism base assembly toward
the front.
I
Door arm
Fig.12
CD mechanism base assembly
Door arm board (L)
CN804
Fig.14
CD mechanism base assembly
Door arm
Power amplifier board
Gear a
CD mechanism base assembly
Main board
CN101
F
CN804
CD mechanism base assembly
Power amplifier board
G
Fig.13
FS-SD1000
F
I
CN705
CN708
Fig.9
CD mechanism base assembly
Fig.10
CN301
Fig.11
Gear a
1-7
Advertisement
