Advertisement
<CD mechanism base assembly>
Prior to performing the following procedure, remove
the CD mechanism base assembly.
Refer to "Dismantling and assembling the CD
mechanism assembly" on page 1-5 for the treatment
of optical pickup.
Removing the speaker terminal board
1.
Remove the screw T attaching the speaker terminal
board on the underside of the CD mechanism base
assembly.
Removing the CD mechanism board / CD
mechanism assembly (See Fig.29 to 34)
1.
Turn over the CD mechanism base assembly and
disconnect the wires from connector CN703 and
CN706 on the CD mechanism board.
2.
Remove the seven screws U
mechanism cover and the CD mechanism board.
3.
Turn back the CD mechanism assembly and detach
the CD mechanism cover while pulling the CD
mechanism assembly outward to release the two
joint tabs marked c.
CD mechanism board
CD mechanism
cover
(See Fig.29)
CD mechanism assembly
attaching the CD
CD mechanism cover
U
CN706
CN703
U
Fig.29
Joint c
Fig.30
CD mechanism assembly
Joint c
Tab
Fig.31
FS-SD1000
Speaker terminal board
T
U
U
Tab
CD mechanism cover
1-11
Advertisement
