Declaration Of Conformity - Bosch PWS 720-125 Original Instructions Manual

OBJ_BUCH-393-003.book Page 25 Thursday, February 14, 2008 3:56 PM
Technical Data
Angle Grinder
Article number
Rated power input
Output power
No-load speed
Grinding disc diameter, max.
Thread of grinder spindle
Weight according to
EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries,
these values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may
vary.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until Dec. 28, 2009),
2006/42/EC (from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
28.01.2008, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
Mounting the Protective Devices
Before any work on the machine itself, pull
the mains plug.
Bosch Power Tools
PWS ... 700-115 720-115
3 603 ... A64 2.. A64 0..
W 705 720
W 380 360
rpm 11000 11000
mm 115 115
M 14 M 14
kg 1.9
/ II
Protection Guard for Sanding
Place the protection guard 6 onto the spindle
collar of the machine until the encoding keys of
the protection guard agree with the spindle col-
lar. Press and hold the release lever 1while do-
ing this.
Press the protection guard 6 onto the spindle
collar until the shoulder of the protection guard
is seated against the flange of the machine, and
turn the protection guard until it can clearly be
heard to engage.
Adjust the position of the protection guard 6 to
the requirements of the work process. For this,
press the release lever 1 upward and turn the
protection guard 6 to the required position.
Adjust the protection guard 6 in such a man-
ner that sparking is prevented in the direc-
tion of the operator.
The protection guard 6 may be turned only
upon actuation of the release lever 1! Oth-
erwise the power tool may not continue to
be used under any circumstances and must
be taken to an after-sales service agent.
Note: The encoding keys on the protection
guard 6 ensure that only a protection guard that
fits the machine type can be mounted.
English | 25
720-125 750-115
A64 0.. A64 1..
720 750
360 450
11000 11000
125 115
M 14 M 14
1.9 1.9 1.9
/ II / II / II
1 609 929 R16 | (14.2.08)
750-125
A64 1..
750
450
11000
125
M 14
1.9
/ II