Commissioning; Initial Installation; Switching On And Off; Carrying Out Basic Settings - AEG DVB-T 4544 Instruction Manual

Купить в интернет-магазине http://clatronic-shop.com.ua
ENGLISH
32
Connection schematic

Commissioning

 Insert the mains plug of the receiver in a regulation
power socket with PE for 230 V, 50 Hz.
 Press the power switch " " on the front side of the
device.
 Insert the connected devices' mains plug into the
mains socket and switch these on.
 Switch on the AV channel on the TV set.
Please refer to your TV set's operating instructions
for information on how to switch the "AV" chan-
nel on.

Initial Installation

The first time the device is switched on the start window
of the installation assistant appears. With the help of the
installation menu you can easily make the most important
adjustments to the receiver.
 Use the "▼ CH-" or "▲ CH+" cursor buttons to select
the desired option. Select by using the "► V+" or
"◄ V-" cursor buttons. Start the automatic channel
search with the "red" button.
 As soon as the Installation assistant has finished the
search run (100%), the device switches to TV mode.
ТВ-ресивер AEG DVB-T 4544

Switching on and off

 In order to switch the device on or off, press the " "
 In order to switch between standby and operational

Carrying out basic settings

Navigating in menus and sub-menus

 In order to switch between the menu options, press the
 To confirm the selected menu option, press the "OK"
The settings for this menu option are displayed.
 To move from one setting to the next, press the "▼
The selected setting is marked.
 By pressing the OK button you jump to the settings
 You may:
 Press the "EXIT" button to change back to the last
 In order to exit the main menu, press the "EXIT" button
The on-screen menu is closed and the screen is switched
to TV or radio mode.
The system settings must be adjusted to enable you to use
the receiver's full range of functions (see the following
Chapter).
 Press the "MENU" button on the remote control.
on/off power switch on the device.
mode, press the "STANDBY " button on the remote
control.
"►V+, ◄ V-, ▼ CH-, ▲ CH+" buttons on the remote
control.
button.
CH-" and "▲ CH-" cursor buttons.
menu.
- switch between the options with the "◄ V-,
▲ CH+, ▼ CH-, ► V+" cursor buttons.
- use the numeric buttons to enter numbers if the
setting requires a numerical input.
menu level.
repeatedly.