Table of Contents
Advertisement
SPEED DIAL
The handset can store up to 10 phone numbers in its memory. You can dial a stored
number simply by pressing -j
and the assigned l-digit memory location
number.
To store numbers in memory
1.
2.
3.
Press [~1.
The TALK indicator flashes.
The dialing buttons light for approximately 10 seconds.
Dial the phone number you want to store.
If you maka an error while storing a number, press ~
to cancel the operation.
To resume, begin with stap 1.
— Up to 16 digits can be stored. (A pauae munte es one digit.)
Press 1~[.
1
4. Press a number button (O - 9) to assign a memory location number to the phone
number.
%..
A beep sounds. The diating button tight goes oft. The phone number is now stored
in the handset memory.
5. Write the stored phone number on the speed dial directory sheet (included).
6. Repeat slaps 1-5 to stora other numbers or to change previously stored numbers.
To ineeR a pau=
Stored phone numbers can include a 2-second pauaes between two digits (after 1 to
get an outside line in a PBX system, for example). Press p]
atterthe first digit.
NOTE:
To dear a stored phone number, press 1~1
twice, and then the asaigned
index number.
To dial a number stored in the memory
1. Press 1-
orl~l.
@or@
2. Press -1
3. Enter the Iceetion number (O-9).
The apead dial memory maybe erased if the handset battery is replaced orexheueted.
11
REDIAL
You can automatically redial the last number called using [~[
on the handset.
A number of up to 32 digits can be redialed.
NOTE:
To redial after hearing a busy signal, press ~,
then [~
or ~,
then
~.
FLASH BUITON
Youcanusa~~
toanewertheeecondparly
when you subacribeCALL WAITING
seivice offered by your phone company and PBX system.
If you subscribe to CALL WAITfNG...
1.
2.
3.
If a call cornea in when you are already on the phone, a beep sounds.
Press ~].
The first cell is placed on hold, and you can talk to the second caller.
3
Press =
again.
The second caller is placed on hold, and you can talk to the first caller.
8
NOTE PHI
may also be used to get a new dial tone without pressing' ~
or
replacing the handset in the base station cradle. However, if your telephone tine has
special service features (fike CAU WAITING), ~]
may not operate in this way.
HANDSET LOCATOR
If you misplace the handset, press ~{
on the base station to maka the
handset baep.
m
NOTE
If the handset RINGER switch is set to the off position, no beep will be produced.
12
Advertisement
Table of Contents
