Magicsafe Ms660 - Waeco MagicSafe MS660 Installation And Operating Manual

_MS660.book Seite 71 Montag, 2. August 2010 8:03 20

MagicSafe MS660

No. Designation
18 Ultrasonic module
19 White plug connection ultrasonic sensor – ultrasonic module
20 Simultaneous connection to door contact switch and to the boot contact switch
(with inverse diodes only!)
21 Connection to door contact switches only (without inverse diodes!)
22 Red plug connection for key holder
23 White plug connection for key holder
24 Key holder incl. status LED
All plugs are coded so that you cannot connect them incorrectly.
7.1 Laying cables
When laying the cables, make sure:
they are not kinked or twisted
they do not rub on edges
they are not laid in sharp-edged ducts without protection (fig. 3, page 3).
NOTICE!
A
Before drilling any holes, make sure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing (fig. 2, page 3).
➤ When laying cables in the engine compartment or boot, use existing
openings with rubber seals wherever possible.
Where there is no suitable opening, drill a hole with a diameter of
approximately 13 mm, and insert a cable duct sleeve.
NOTE
I
Pull the socket connectors of the cables through the cable duct
sleeve before inserting the sleeve in the bodywork.
➤ Lay the cables in the engine compartment or boot so that they cannot be
damaged under any circumstances (e. g. by flying stones).
➤ Insulate all unused cable ends.
Connecting the power to MagicSafe
71