Direct Code Entry - One for All OARN03S User Manual

6.
Point the remote directly at the front panel of the device
2 seconds. The remote is testing a single code for your
Did your device turn off?
YES:
NO:
your brand.
NOTES
Throughout the programming of each key, be sure to keep the
remote pointed at the IR sensor of the device you are currently
programming the remote to control.
Test the remote with the device to make sure the device key is
programmed with the correct code for maximum functionality.
If some features don't work, try a different code. See the
"Testing the Code for Maximum Functionality" section below
for more information.
During the Brand Code Search, the remote ignores keypresses
that aren't part of the search.
The search times out after two minutes (the POWER key blinks
four times and turns off, and the last programmed code under
that device key is retained).
The POWER key blinks four times and turns off when the
remote has gone through all the codes. The remote exits the
Brand Code Search. If your device hasn't turned off yet, try a
different search method.
Testing the Code for Maximum Functionality
1.
a different code.
2.
3.
4.
programming is complete. If the code stored does not give

Direct Code Entry

TIP: Each device key is associated with a type of device—the TV
1.
2.
continues on next page...
5