Auto Code Search - One for All OARN03S User Manual

Auto Code Search

that code.
TIPS: Each device key is associated with a type of device—the
section.
To exit without saving a new code at any point in the Auto
Code Search, press the EXIT key.
1.
2.
3.
4.
Point the remote directly at the front panel of the device
seconds. The remote is testing a batch of 10 codes on your
device.
Did your device turn off?
YES:
NO:
10 codes.
off.
5.
last of the previous ten codes.
Did your device turn on?
YES:
NO:
the batch.
Note: If you accidentally press the REVERSE key after your
device turns on, press the FORWARD key. Then, wait two
seconds to see if your device turns off again.
NOTES
Throughout the programming of each key, be sure to keep the
remote pointed at the IR sensor of the device you are currently
programming the remote to control.
Test the remote with the device to make sure the device key is
programmed with the correct code for maximum functionality.
If some features don't work, try a different code. See the
"Testing the Code for Maximum Functionality" section on the
next page for more information.
continues on next page...
3