One for All OARN03S User Manual page 7

3.
4.
Point the remote directly at the front panel of the device
2 seconds. The remote is testing a single code for your
device.
Did your device turn off?
YES:
NO:
your device.
TIP: Because there are so many codes, you may have to
press the POWER key many times—possibly hundreds of
times.
NOTES
Throughout the programming of each key, keep the remote
pointed at the IR sensor of the device you are programming the
remote to control.
Test the remote with the device to make sure the device key is
programmed with the correct code for maximum functionality.
If some features don't work, try a different code. See the
"Testing the Code for Maximum Functionality" section below
for more information.
During the Manual Code Search, the remote ignores keypresses
that aren't part of the search.
The search times out after two minutes (the POWER key blinks
four times and turns off, and the last programmed code under
that device key is retained).
The POWER key blinks four times and turns off when the
remote has gone through all the codes. The remote exits the
Brand Code Search. If your device hasn't turned off yet, try a
different search method.
Testing the Code for Maximum Functionality
1.
step to try a different code.
2.
3.
4.
7