Brother bas-311hn Instruction Manual page 24

3. INSTALLATION
Operator
16
Green and yellow wire
(ground wire)
BAS-311HN, BAS-326H
<100 V / 400 V system >
(1) Power switch
(2) Wood screws [2 pcs.]
3146B
(3) Transformer box
2348B
(4) Transformer box plates [2 pcs.]
(5) Screws [with washer] [4 pcs.]
(6) 3-pin power supply connector
(7) Staples [6 pcs.]
(8) Cord clamps [2 pcs.]
(9) Power cord
1. Attach an appropriate plug to the
power cord (9). (The green and yellow
wire is the ground wire.)
2. Insert the power
properly-grounded AC power supply.
* The inside of the control box uses
single-phase power.
NOTE:
• If the ground connection is not secure,
electric shocks, operating errors or
damage to electronic components such
as P.C. boards may occur.
• Take care when tapping in the staples
(7) to make sure that they do not pierce
the cords.
• Do not use extension cords, otherwise
machine operation
result.
3. Use the six screws to tighten the cover
of the control box. Check that none of
the cords are being clamped by the
cover at this time.
3658B
plug into a
problems may