D-Link DIR 635 B3 User Manual page 34

Section 3 - Configuration
DHCP stands for Dynamic Host Control Protocol. The DIR-635 has a built-in DHCP server. The DHCP Server will automatically assign
an IP address to the computers on the LAN/private network. Be sure to set your computers to be DHCP clients by setting their TCP/IP
settings to "Obtain an IP Address Automatically." When you turn your computers on, they will automatically load the proper TCP/IP settings
provided by the DIR-635. The DHCP Server will automatically allocate an unused IP address from the IP address pool to the requesting
computer. You must specify the starting and ending address of the IP address pool.
Enable DHCP
Check this box to enable the DHCP server on your router.
Server:
Uncheck to disable this function.
DHCP IP Address
Enter the starting and ending IP addresses for the DHCP
Range:
server's IP assignment.
Note: If you statically (manually) assign IP addresses to
your computers or devices, make sure the IP addresses are
outside of this range or you may have an IP conflict.
DHCP Lease Time: The length of time for the IP address lease. Enter the Lease
time in minutes.
Always Broadcast:
Enable this feature to broadcast your networks DHCP server
to LAN/WLAN clients.
NetBIOS NetBIOS allows LAN hosts to discover all other computers
Announcement:
within the network, enable this feature to allow the DHCP
Server to offer NetBIOS configuration settings.
Learn NetBIOS Enable this feature to allow WINS information to be learned from the WAN side, disable to allow manual configuration.
from WAN:
NetBIOS Scope:
This feature allows the configuration of a NetBIOS 'domain' name under which network hosts operates. This setting has no
effect if the 'Learn NetBIOS information from WAN' is activated.
NetBIOS Node: Select the different type of NetBIOS node; Broadcast only, Point-to-Point, Mixed-mode, and Hybrid.
WINS IP Address: Enter your WINS IP address
D-Link DIR-635 User Manual
DHCP Server Settings
30