Connect To Another Router - D-Link DIR 635 B3 User Manual

Section 2 - Installation
If you are connecting the D-Link router to another router to use as a wireless access point and/or switch, you will have
to do the following before connecting the router to your network:
• Disable UPnP
™
• Disable DHCP
• Change the LAN IP address to an available address on your network. The LAN ports on the router cannot
accept a DHCP address from your other router.
To connect to another router, please follow the steps below:
1. Plug the power into the router. Connect one of your computers to the router (LAN port) using an Ethernet cable.
Make sure your IP address on the computer is 192.168.0.xxx (where xxx is between 2 and 254). Please see the
Networking Basics section for more information. If you need to change the settings, write down your existing settings
before making any changes. In most cases, your computer should be set to receive an IP address automatically in
which case you will not have to do anything to your computer.
2. Open a web browser and enter http://192.168.0.1 and press Enter. When the login window appears, set the user
name to Admin and leave the password box empty. Click Log In to continue.
3. Click Advanced and then click Advanced Network. Uncheck Enable UPnP and click Save Settings to continue.
4. Click Setup and then click Network Settings. Uncheck Enable DHCP Server and click Save Settings to
continue.
5. Under Router Settings, enter an IP address and the subnet mask of your network. Click Save Settings to save
your settings. Use this new IP address to access the configuration utility of the router in the future. Close the browser
and change your computer's IP settings back to the original values as mentioned in step 1.
D-Link DIR-635 User Manual

Connect to Another Router

9