Cleaning The Hose And Nozzle - Electrolux Cyclone Power z7292 Manual

1
2
3

CLEANING THE HOSE AND NOZZLE

The vacuum cleaner stops automatically if the nozzle, tube
or hose becomes blocked, or the filters are blocked.
Disconnect from the mains and allow the vacuum cleaner to
cool down for approximately 20-30 minutes. Clear whatever
is causing the blockage and/or replace dirty filters.Then
restart the vacuum cleaner.
Tubes and hose
1. Use a cleaning strip or similiar to clear the tubes and
hose.
2. It is sometimes possible to clear the hose by "massag-
ing" it. However, be careful in case the obstruction has
been caused by glass or needles caught inside the hose.
Note: The warranty does not cover any damage to hoses
caused by cleaning them.
Cleaning the floor nozzle
3. To avoid reduction in suction power, frequently clean the
dual purpose floor nozzle. The easiest way to clean it is
by using the hose handle.
7