Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Electrolux Cyclone Power z7292
Summary of Contents for Electrolux Cyclone Power z7292
-
Page 3: Table Of Contents
Thank you for choosing an Electrolux Cyclone Power vacu- um cleaner. These operating instructions cover all Cyclone Power models. This means that with your specific model, some accessories may not be included. Accessories and safety precautions Before starting Getting the best results... -
Page 4: Accessories And Safety Precautions
Electrical cable precautions: • A damaged cable must be replaced by an authorised Electrolux service engineer. Damage to the cleaner cable will not be covered by the warranty. • Never pull or lift the vacuum cleaner by the cable. -
Page 5: Before Starting
BEFORE STARTING 1. Always operate the cleaner with the dust container installed. 2. Always operate the cleaner with the filter set property installed. 3. Insert the hose until the catch clicks to engage (press the catch to engage hose). 4. Attach the plastic tubes (Z7211) or metal tubes (Z7292) to the hose handle and the floor nozzle. -
Page 6: Removing The Contents Of The Dust Container
REMOVING THE CONTENTS OF THE DUST CONTAINER Never operate the cleaner without the dust container installed. The dust container must be emptied if the window of the dust container indicator is red when the cleaner is operating at max- imum power and the nozzle is raised from the floor. Never open the top cover with the hose connected to the cleaner . -
Page 7: Cleaning The Motor Filters And The Micro Exhaust Filter
Cleaning the motor filters Motorfilter ‘A’ 1. Open the top cover. 2. Remove the dust container from the cleaner. 3. Remove the filter set from the dust container by taking it as indicated in the icon. 4. Remove the cartridge filter by turning it counter-clock- wise (A) and pull it out (B) as indicated in the icon. -
Page 8: Cleaning The Hose And Nozzle
CLEANING THE HOSE AND NOZZLE The vacuum cleaner stops automatically if the nozzle, tube or hose becomes blocked, or the filters are blocked. Disconnect from the mains and allow the vacuum cleaner to cool down for approximately 20-30 minutes. Clear whatever is causing the blockage and/or replace dirty filters.Then restart the vacuum cleaner. -
Page 9: Troubleshooting And Customer Information
Damage to the motor caused by the penetration of water is not covered by the warranty. Customer Information Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tam- pering with the appliance. This product is designed with the environment in mind. -
Page 10: Electrical Supply Instructions
In case of doubt, have it done by a qualified elec- the event of the fuse requiring replacement the fuse cover should trician, as Electrolux cannot regard the repair of faults on the plug be removed using a small screwdriver. The old fuse MUST be... -
Page 11: Warning Instructions
When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL THE INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: • Do not use outdoors or on wet surfaces. •... -
Page 12: Guarantee
The guarantee may be invalidated by unauthorised repair or modification of the appliance. d. You may be charged by the Electrolux Group if you call for an engineer to resolve a problem that we believe is covered in the instruction booklet.