Removing The Contents Of The Dust Container; Cleaning The Cartridge Filter - Electrolux Cyclone Power z7292 Manual

2
1
4
5
7

REMOVING THE CONTENTS OF THE DUST CONTAINER

Never operate the cleaner without the dust container installed.
The dust container must be emptied if the window of the dust
container indicator is red when the cleaner is operating at max-
imum power and the nozzle is raised from the floor.
Never open the top cover with the hose connected to the cleaner .
1. Open the top cover.
2. Remove the dust container from the cleaner.
3. Remove the filter set from the dust container by taking it
3
in the way indicated
4. Remove the contents of the dust container.
3. Put the filter set back into the dust container.
2. Put the dust container back into the cleaner.
1. Close the top cover.
Note: Empty the dust container even if it is not full (the filters may be
blocked). Also replace after using carpet-cleaning powder.
CLEANING THE FILTERS
Filters should be cleaned regularly and replaced twice a year.
6
Disconnect from electrical outlet before cleaning filters.
Your cleaner is fitted with a dust container indicator. Before
commencing cleaning, without the hose attached, check the
dust container indicator.
If red, clean or replace filter, if not, attach the hose, extension
tubes and accessories as normal and continue cleaning.
NB: It is normal for the indicator to be red during cleaning.

Cleaning the cartridge filter

Always operate the cleaner with the cartridge filter installed.
1. Open the top cover.
2. Remove the dust container from the cleaner.
3. Remove the filter set from the dust container by taking it
as indicated.
5. Remove the cartridge filter by turning it counter-clock-
wise (A) and pull it out (B) as indicated.
6. Rinse it under tap water.
7. Air dry for approximately 24 hours, to ensure it is com-
pletely dry before re-using. Avoid direct sunlight and
extreme drying circumstances (hair-dryer, etc.).
If you wish to use your appliance while the cartridge filter
is drying, you may use the extra cartridge filter inserted in
the packaging box.
5. Insert the cartridge filter into its place (B) and turn it
clockwise (A) as indicated in the icon.
3. Put the filter set back into the dust container.
2. Put the dust container back into the cleaner.
1. Close the top cover.
5