Factory Default - NetComm NB620W User Manual

Netcomm super-g wireless gateway user guide
Hide thumbs Also See for NB620W:
Table of Contents

Advertisement

1.6 Factory Default

Reset Button. Press and hold the reset button for more than 7 seconds; the gateway will be
restored to factory default values. All of your saved configurations will be gone, so please
backup your current configuration before using the Reset Button..
1.6.1 Log-in
User Name
The default username of the NB620W is "admin".
Password
The default password of the NB620W is "admin". It is highly recommended that you setup
your own password to prevent unauthorized access to the Gateway's settings.
First time login
You can directly access the configuration manager home page after you enter the IP address:
192.168.1.1 and the default username and password.
Forgot your password?
If you forget the password, you can reset the device to its factory setting. Press the "Reset"
button on the back panel of the NB620W Gateway. Hold the button in at least 10 seconds. The
NB620W will revert to its default settings. Then, you can configure the Gateway again.
Security
It is recommended that you change the admin password and disable wireless, remote manage-
ment and UPnP until you require these functions or you take suitable security measures (e.g.
Set WEP Keys).
1.6.2. Management / Gateway Address
The NB620W gateway address, also the address for management utility, is 192.168.1.1. Please
login the Management Utility or setup your gateway on this address. [Please refer to Chapter 3
Configuring the Wireless Gateway for more information.]
If your computer supports Microsoft Universal Plug and Play (UPnP), once the Gateway is
plugged into the same physical network, your station will detect it.
NB620W Super-G Wireless Broadband Gateway User Guide
10
YML725 Rev1
www.netcomm.com.au

Advertisement

Table of Contents
loading

Table of Contents