Fcc Regulatory Compliance - Pantech pursuit II P6010 User Manual

To ensure that the Hearing Aid Compatibility rating for
your phone is maintained, secondary transmitters such as
Bluetooth and WLAN components must be disabled during a
call. See page 74 for instructions to disable these components.

FCC Regulatory Compliance

FCC Regulatory Compliance
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Your mobile device is a low power radio transmitter
and receiver. When it is ON, it receives and also sends
out radio frequency (RF) signals. In August 1996, the
Federal Communications Commission (FCC) adopted
RF exposure guidelines with safety levels for mobile
devices. Those guidelines are consistent with safety
standards previously set by both U.S. and international
standards bodies: American National Standard Institute
(ANSI), National Council of Radiation Protection and
Measurements (NCRP), and International Commission
84
on Non-Ionizing Radiation Protection (ICNRP). Those
standards were based on comprehensive and periodic
evaluations of the relevant scientific literature. The
design of your phone complies with the FCC guidelines
and applicable.
Statement according to FCC part 15.105
note: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.