Feeding The Line - ALDI 50750 User Manual

26cc 2 Stroke Line Trimmer

Feeding the line

The line trimmer has a bump feed mechanism which releases the line without
having to stop the engine.
1. To release additional line, lightly tap the bump knob (20) on the ground
while operating the unit at high speed.
NOTE: Always keep the line fully extended. Line release becomes more
difficult as the cutting line becomes shorter.
2. Each time the knob is bumped it releases approximately 2cm of line.
Release the line until it strikes the cut off knife (19). This may require
several taps.
NOTE: The cut off knife (19) on the guard (16) will automatically cut off
any excess line. For best results tap the bump knob (20) on hard soil or
bare ground. Never bump the bump knob (20) on concrete as it may
crack the spool housing.
IMPORTANT: Do not hit stones (even small ones), piles of earth, and
small pieces of wood or anything else that could be hidden or poorly
visible in the grass. If you hit a large object by accident, or if you block the
cutting tool due to overloading or having the cutter jammed with grass,
you must stop the engine and clear the jammed cutter, and check for any
damage to the cutter, spool or guard.
NOTE: All protective devices of the machine as well as protective
equipment must be maintained in good operation condition during the
period of use.
NOTE: If the line is too short you may not be able to advance the line by
tapping it on the ground. If this is the case, stop the engine and manually
advance the line.
AFTER SALES SUPPORT
1800 909 909
(toll free)
e-mail: help@powertoolsupport.com
MODEL: №. 50750 • 11/2015 • WLBC260X-2WNO
Feeding the line
25