Warm Start; Stopping The Line Trimmer - ALDI 50750 User Manual

26cc 2 Stroke Line Trimmer
7. To engage the clutch so the spool and line start
to rotate, you need to increase the speed of the
engine. As the speed of the engine increases,
the clutch will engage the spool and line.
8. To increase the speed of the cutting line,
squeeze the safety lever (9) first, and then
squeeze the throttle trigger (8). (Fig AI)
To reduce the speed of the cutting line release
the throttle trigger (8). (Fig AJ)
The speed of the spool and line can be varied
depending on the amount the throttle trigger
(8) is depressed.
When the throttle trigger (8) is released, the
engine will return to the idle speed and the
clutch will disengage.
NOTE: The line head may take a few seconds to
run down after disengagement of the clutch.

Warm Start

When re starting the line trimmer after it has been used and the motor is
hot, there is no need to engage the choke (red lever) (17). Follow steps
4, 5, 6,7 and 8 in the previous section.

Stopping the Line Trimmer

WARNING: The spool and line will rotate
whenever the motor is operating above the
idle speed.
The spool and line may run down after the engine has
been slowed to idle for a few seconds.
Do not continue to use the line trimmer if the spool
and line is rotating when the engine is at idle speed.
1. Release the throttle trigger (9) and allow the
engine to idle for a few moments.
2. Move the On/Off switch (10) to the "Off" position marked with an "O". (Fig AK)
3. The engine will now stop.
AFTER SALES SUPPORT
1800 909 909
(toll free)
e-mail: help@powertoolsupport.com
MODEL: №. 50750 • 11/2015 • WLBC260X-2WNO
Operation
AI.
AJ.
AK.
21