Table of Contents
Advertisement
REFERENCES
Change the display information
Each time you press DISP, the display information changes.
• If the information is unavailable or not recorded, "NO TEXT", "NO INFO", or other information
(eg. station name, playing time) appears.
Source name Display information
STANDBY
Source name
Clock
TUNER
Frequency
Clock
(back to the beginning)
(For FM Radio Data System stations only)
Station name
Radio text
(back to the beginning)
USB
(For MP3/WMA/WAV/FLAC files)
Track title/Artist
Album title/Artist
Playing time
Clock
IPOD or
Track title/Artist
Album title/Artist
ANDROID
(back to the beginning)
PANDORA
Station name
Shared / Radio station
Playing time
Clock
(back to the beginning)
AUX
Source name
Clock
(back to the beginning)
Radio text+
Title/Artist
Frequency
Folder name
File name
(back to the beginning)
Playing time
Clock
Track title
Artist
Album title
(back to the beginning)
INSTALLATION / CONNECTION
Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
• Insulate unconnected wires with vinyl tape to prevent a short circuit.
• Be sure to ground this unit to the car's chassis again after installation.
Caution
• For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer.
Clock
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the [ wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned
on and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old
fuse with one that has the same rating.
Basic procedure
1
Remove the key from the ignition switch, then disconnect the [
terminal of the car battery.
2
Connect the wires properly.
See Wiring connection. ( 17)
3
Install the unit to your car.
See Installing the unit (in-dash mounting).
4
Connect the [ terminal of the car battery.
5
Reset the unit. ( 3)
15
ENGLISH
Hide quick links:
Advertisement
Table of Contents
