Playing Back With High Quality Sound Codec (Aac/Ldac™) - Sony MHC-V11 Operating Instructions Manual

1
Touch the mobile device, such
as a smartphone or tablet, to
the N-Mark on the unit until
the mobile device vibrates.
Complete the connection by
following the instructions displayed
on the smartphone.
When the BLUETOOTH connection
is established, the BLUETOOTH
indicator on the unit stops flashing
and remains lit. "BT AUDIO" appears
on the display.
2
Start playback of an audio
source on the smartphone.
For details, refer to the operating
instructions of your BLUETOOTH
device.
Hint
If pairing and the BLUETOOTH connection
fail, perform the following.
— Remove the case from the smartphone
if using a commercially available
smartphone case.
— Touch the smartphone to the N-Mark on
the unit again.
— Relaunch the "NFC Easy Connect"
application.
To terminate the BLUETOOTH
connection
Touch the smartphone to the N-Mark
on the unit again.
24
GB
Playing back with high
quality sound codec
(AAC/LDAC™)
This system can receive data in the
AAC or LDAC codec format from a
BLUETOOTH device. It provides a
playback with higher sound quality.
The default setting of this system is
"AUTO."
To apply the changes of the setting,
you need to terminate the BLUETOOTH
connection (page 23), and then
perform the BLUETOOTH connection
again.
1
Press BLUETOOTH on the
unit to select the BLUETOOTH
function.
"BT AUDIO" appears on the display.
2
Press OPTIONS.
3
Press / repeatedly to select
"BT:CODEC," then press
4
Press / repeatedly to select
the setting, then press
• AUTO: The system detects the
codec used on the source device
and automatically selects the
optimal codec from "SBC," "AAC*"
or "LDAC*."
• SBC: "SBC" is always applied
regardless of the codec used on
the source device.
* Available only when the codec is
supported by your BLUETOOTH device.
Note
You can enjoy higher sound quality
when the source device is compatible
with AAC/LDAC and this function is set
to "AUTO." However, the sound may be
interrupted depending on the conditions
of the BLUETOOTH communication. If this
happens, set the function to "SBC."
.
.