Appendix C: Registration And Warranty Information - NetComm 4-port and 8-port Gateways Gateway Series Reference Manual

4-port and 8-port gateways
Table of Contents

Advertisement

Appendix C: Registration and Warranty Information

All NetComm Limited ("NetComm") products have a standard 1 month warranty from date of purchase against defects in manufacturing and that
the products will operate in accordance with the specifications outlined in the User Guide. However some products have an extended warranty
option (please refer to your packaging). To be eligible for the extended warranty you must supply the requested warranty information to NetComm
within 30 days of the original purchase by registering on-line via the NetComm web site at:
Contact Information
If you have any technical difficulties with your product, please do not hesitate to contact NetComm's Customer Support Department.
Email:
support@netcomm.com.au
Fax:
(+61) 944-010
Web:
www.netcomm.com.au
Copyright Information
This manual is copyright. Apart from any fair dealing for the purposes of private study, research, criticism or review, as permitted under the
Copyright Act, no part may be reproduced, stored in a retrieval system or transmitted in any form, by any means, be it electronic, mechanical,
recording or otherwise, without the prior written permission of NetComm Limited. NetComm Limited accepts no liability or responsibility, for
consequences arising from the use of this product. Please note that the images used in this document may vary slightly from those of the actual
product. Specifications are accurate at the time of the preparation of this document but are subject to change without notice.
NetComm Limited reserves the right to change the specifications and operating details of this product without notice. NetComm is a registered
trademark of NetComm Limited. All other trademarks are acknowledged the property of their respective owners.
Customer Information
ACA (Australian Communications Authority) requires you to be aware of the following information and warnings:
(1) This unit shall be connected to the Telecommunication Network through a line cord which meets the requirements of the ACA
TS008 Standard.
() This equipment has been tested and found to comply with the Standards for C-Tick and or A-Tick as set by the ACA. These
standards are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio noise and, if not installed and used in accordance with the instructions detailed within this
manual, may cause interference to radio communications. However, there is no guarantee that interference will not occur with the
installation of this product in your home or office. If this equipment does cause some degree of interference to radio or television
reception, which can be determined by turning the equipment off and on, we encourage the user to try to correct the interference
by one or more of the following measures:
Change the direction or relocate the receiving antenna.
Increase the separation between this equipment and the receiver.
Connect the equipment to an alternate power outlet on a different power circuit from that to which the receiver/TV is con-
nected.
Consult an experienced radio/TV technician for help.
(3) The power supply that is provided with this unit is only intended for use with this product. Do not use this power supply with any
other product or do not use any other power supply that is not approved for use with this product by NetComm. Failure to do so
may cause damage to this product, fire or result in personal injury.
9
www.netcomm.com.au
SmartVoice Gateway(s) User Guide
YML83 Rev

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sm5695Smartvoice seriesSmartvoice v404Smartvoice v808

Table of Contents