Operation - HAKO FM-202 Instruction Manual

2. Operation:

First, remove any excess solder from the tip
by thrusting the tip into the cleaning wire.
(Do not wipe the tip against the wire. This
may cause molten solder to spatter.)
When the wire become dirty or loaded with
solder, turn the wire until a clean surface is
presented.
When changing the cleaning wire, lift the
case top vertically to prevent solder debris
from falling out.
3. Place the spare tips in the tip tray.
B. Connector cord
Pass the connector cord through the hole in the
heat resistant pad.
C. Soldering station
1. Insert the power cord into the receptacle at
the back of the station.
2. Insert the connector cord into the receptacle
at the front of the station.
3. Plug the power cord into a grounded wall
socket. The FM-202 is protected against
electrostatic discharge and must be
grounded for full efficiency.
When the plug clicks ,
it is fully inserted.
Push the plug in as far as
it will go, and try to remove it
without pressing the release pin.
If it stays in the receptacle
it is properly seated.
Receptacle
4