Tip Identification Number - HAKO FM-202 Instruction Manual

7. TIP IDENTIFICATION NUMBER

Entering the Tip ID
T7-D24
Part number
CAUTION:
Do not damage or remove the Tip ID bar code sticker.
How to read out the bar code of
the tip into the FM-202:
1. Insert the tip (connector side) into the
process gate in the front of the station.
2. Insert the tip until the buzzer sound once.
The display shows
indicator will stop flashing. Now the tip
identification number has been stored.
9
Tip ID Bar code
1Y100CB3 01
Serial number
. The LED
Soldering tips have different thermal chara-
cteristics, depending upon their mass, shape, and
surface area. It should be obvious that the tip
temperature at idle will not be the same for a fine
tip as it will be for a heavy chisel tip, although the
set temperature may be the same for each tip. The
FM-202 processor incorporates the ability to
electronically compensate for tip geometry
variations using Tip IDs. Each FM-202 tip style has
a specific Tip ID; whenever a tip is changed, the
Tip ID should be entered into the FM-202 for most
effective process control.
There are two ways to enter Tip ID data into the
FM-202:
See below or page 6 of this manual. This procedure
is the simplest and most common.
See Appendix A of this manual, when the Tip ID is
not readable for some reason.
NOTE:
When the buzzer sounds three times is reading error, insert
the tip again.
CAUTION:
Do not insert the tip opposite side or other incompatible tip.
CAUTION:
When tip is inserting the FM-2021, the process gate cannot
read the bar code. If a tip insert into the process gate while
the tip is already in the FM-2021, buzzer will sound
irregularity. Remove the tip from the FM-2021 for reading the
Tip ID.