Page 2
5. OPERATION 6. PARAMETER SETTINGS 7. ERROR MESSAGES l Replacing the tip The HAKKO FX-951 comes from the factory with The HAKKO FX-951 has the following four parameters: l Sensor Error When there is the possibility that a failure has the following values preset.
Page 3
WARNING 2. MAINTENANCE/CHECKING PROCEDURE Before checking the inside of the HAKKO FX-951 or replacing parts, be sure to disconnect the power plug. Failure to do so may result in electric shock. Performing proper and periodical maintenance extends the products life and contributes to use it always in Tapping screw a good condition.