Warning Messages - Hitachi RX2 Instruction Manual

No. Message
Internal
63 Communication
Error M

9.2.2 Warning messages

No. Message
Excitation V-ref.
65
Review
Viscosity Reading
66
Instable
Viscosity
67 Readings Out of
Range
68 Ink Viscosity High The ink viscosity is above the proper level.
69 Ink Viscosity Low Ink viscosity is below the proper level.
71 Battery Low M
Calendar Content
72
Inaccurate
External
- Communication
Error nnn
Excitation V-ref.
80
Review 2
81 Ink Low Warning
Meaning of message
The internal data processing error.
Meaning of message
The excitation voltage reference needs to
be updated.
The viscometer output readings fluctuated.
Setting will be temporarily switched to no
use of viscometer.
The viscometer is defective.
Setting will be temporarily switched to no
use of viscometer.
The internal battery in engine section is
low.
The latest print data and operating
information may not be saved.
Calendar content is inaccurate due to mal-
function of the clock.
The serial communication port had a date
error.
Up date the excitation voltage reference.
Print quality may become poor.
The ink level in the ink reservoir is low.
Remedy
● Ink stop and the printer power
OFF are recommend.
Turn the printer OFF and then
back ON after 10 seconds.
Remedy
● Perform the Nozzle test and
update the Excitation V-ref.
setting.
( Technical manual 6.10)
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● The ink concentration will be
adjusted to normal level.
If print quality is still poor,
then replace ink.
( Technical manual 6.3)
● The ink concentration will be
adjusted to normal level.
If print quality is still poor,
then replace ink.
( Technical manual 6.3)
● Contact your nearest local
distributor.
● Replace the internal battery
in engine section and set the
data/time. ( 6.2).
● Contact your nearest local
distributor.
● Set the date/time. (
● Note the error code and see
that no more errors occur.
( Technical manual 5.7)
● Perform nozzle test and
update the excitation V-ref.
setting.
( Technical manual 6.11)
● Watch for the print results and
the Excitation V-ref.
Setting. for about 2 hours
after operation is started.
● Add ink within 60 minutes
( 8.1).
●On-screen message descriptions 9-7
6.2).