Receiving Call - Kenwood KDC-BT49DAB Instruction Manual

BLUETOOTH®
BLUETOOTH — Mobile phone
Receive a call
When there is an incoming call:
– All the buttons and display flash.
– The unit answers the call automatically if [AUTO ANSWER] is set to a selected time. ( 13)
During a call:
– The buttons and display illuminate according to the settings made for [DISPLAY]. ( 17)
– If you turn off the unit or detach the faceplate, the Bluetooth connection is disconnected.
To
Answer a call
Reject a call
End a call
Adjust the phone volume
[00] to [35] (Default: [15]*)
Switch between hands-
free and private talk
modes
* Not applicable for iPhone. During a call, the unit synchronizes the phone volume on the iPhone to the unit.
12
On the faceplate
Press or the volume knob or one of the number buttons
(1 to 6).
Press .
Press or .
Turn the volume knob during a call.
• This adjustment will not affect the volume of the other sources.
Press during a call.
• Operations may vary according to the connected Bluetooth
device.
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to make a selection
(see the following table), then press the knob.
3 2
Repeat step until the desired item is
selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
MIC GAIN –10 — +10 (–4): The sensitivity of
the microphone increases as the number
increased.
NR LEVEL –5 — +5 (0): Adjust the noise reduction
level until the least noise is being heard
during a phone conversation.
ECHO CANCEL –5 — +5 (0): Adjust the echo cancellation
delay time until the least echo is being heard
during a phone conversation.
.
Default: XX