Horizon Fitness CT83 User Manual page 9

A S S E M BLY STE P 2
HARDWARE BAG 2 CONTENTS :
LEAD WIRES
RIGHT CONSOLE MAST
CONSOLE CABLES
A ull LEAD WIRE through RIGHT CONSOLE MAST. After
P
pulling the LEAD WIRE through the mast, the top of the
CONSOLE CABLES should be located at the top of the
mast. Detach and discard LEAD WIRE.
B HARDWARE BAG 2.
Open
C Move RIGHT LINKAGE ARM into position and attach to
ELEVATION FRAME.
NOTE: While holding RIGHT CONSOLE MAST in the
upright position, tighten PRE-ATTACHED BOLT using
T-wrench to attach RIGHT LINKAGE ARM.
D Attach RIGHT CONSOLE MAST to MAIN FRAME using 1
BOLT (D), 1 FLAT WASHER (E) and 1 WAVY WASHER (F).
E Lift the RUNNING DECK until lock latch on side of
treadmill is fully engaged.
F Remove CONSOLE from box and place out of the way.
G RUNNING DECK from the folded
Lower the treadmill
position by stepping on LOCK LATCH on lower right side.
FLAT WASHER (E)
27 mm
BOLT (D)
Qty: 1
Qty: 1
MAIN FRAME
ELEVATION FRAME CONSOLE CABLES
WAVY WASHER (F)
29 mm
Qty: 1
RIGHT CONSOLE MAST
WAVY WASHER (F) FLAT WASHER (E)
RIGHT LINKAGE ARM
FOOT LOCK LATCH
PRE-ATTACHED BOLT
*
NOTE: If you have attempted to
move the treadmill from the box
and the machine has sprung
open and cannot be assembled,
refer to the troubleshooting
section in order to restore the
treadmill to its proper position.
1
3
BOLT (D)
2
9