Fault Finding Table - PEUGEOT ACI -100 Workshop Manual

FAULT FINDING TABLE FOR THE ACI 100
LIGHTING UP PHASE OF THE LED
PHASE 1 PHASE 2
2sec
0.5sec
0.5sec 2 X 0.5sec
0.5sec 3 X 0.5sec
8
BLACK KEY: IGNITION ON POSITION
INDICATIONS
PHASE 3
ACI 100 not programmed
ACI 100 programmed
- - - - - -
Transponder not recognised
permanent
- - - - - -
Transponder not authorised
permanent
COMMENTS
- Turns at 2000 rpm maximum
- Carry out a memorisation procedure for
the keys.
- No faults found, starting up possible.
- If starting up impossible, see standard
causes of defective ignition (wiring, spark
plug, coil etc).
- Antenna disconnected or break in the
circuit. Check the resistance of the antenna
which must be at17 ohms at the terminals
of the small connector.
- Key without transponder ( try another key,
for example the Master Key, replace the key
if necessary ).
-
Black key not programmed, carry out
programming procedure.
- Black key defective, replace the key and
carry out programming procedure.
- ACI 100 from another vehicle.