Zanussi zfu27400wa User Manual page 23

The appliance must be earthed. The power sup-
ply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is
not earthed, connect the appliance to a sepa-
rate earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two ad-
justable feet at the bottom in front.
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the
compressor cannot touch the floor.
www.zanussi.com
1. Remove the plinth.
2. Unscrew and re-
move the lower hing-
es.
3. Remove the door.
A
B
7. Unscrew the pin
(A) and screw it on
the opposite side.
8. Remove the cap
(B) and position it on
the opposite side.
9. Screw the lower
hinges.
10. Refit the plinth.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cabi-
net. In that case, wait for the natural fitting of the
gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service
2
1
4. Unscrew the upper
pin and screw it on
the opposite side.
5. Refit the door.
6. Make sure the
edge of the door is
parallel with the edge
of the top.
11. Stand the appli-
ance upright.
12. Fit the handle on
the opposite side and
put the plastic caps
(contained in the in-
structions bag) in the
free holes.
23