NEC 320Fc User Manual page 36

Pre-Upgrade Tasks
==============================================
Network Setting
==============================================
Const DefaultGateway
Const VTMOIpAddress
Const VTM1IpAddress
Const Host0IpAddress
Const Host1IpAddress
Const SubNetMask
Const DnsServerIpAddress
Const DhcpEnabled
(1) Figuring default gateway (a)
(2) Configuring the network for Remote KVM Connection (b,c)
(3) Configuring the network for Remote Desktop Connection (d,e)
3. Save the information edited in step 2.
Configuring the VTM IP address
Log on as an administrator or member of Administrators group, and change the IP
addresses specified in VTM using the following procedure.
1. Start Command Prompt by clicking Start, All Programs, Accessories and
Command Prompt.
2. Run the following command in Command Prompt.
After running the command above, make sure that "Finished!" is displayed
in Command Prompt before proceeding.
2-14 Express5800/320Fc: Active Upgrade™ User's Guide
To change the setting of the default gateway, edit the IP address
information in (a).
The IP address in (b) and (c) is used to access the Upgrade Side from the
Production Side using "Remote KVM" when the system is in split mode.
Specify one IP address for each module. Edit the IP address information.
The IP address in (d) and (e) is used to access the Upgrade Side from the
Production Side using "Remote Desktop Connection" when the system is in
split mode. Specify one IP address for each module. Edit the IP address
information.
> CScript//nologo "C:\Program Files\ftsys\VTM\UTMNetConfig.vbs"
= "192.168.1.1"
= "192.168.1.2"
= "192.168.1.3"
= "192.168.1.4"
= "192.168.1.5"
= "255.255.255.0"
= "0.0.0.0"
= false
a
b
c
d
e