Operating Instructions - Kobalt SGY-AIR135TZ User Manual

ASSEMBLY INSTRUCTIONS
Connect the air supply hose to the male plug. Set
the working pressure at 90 PSI for best tool
performance (See Figure 7).
NOTE Working pressure refers to the air line
pressure set to tool when tool is under working
conditions.

OPERATING INSTRUCTIONS

1. Press the trigger (F) to start the tool (See
Figure 1).
NOTE The tool features an air regulating knob
(E). The tool speed can be adjusted by turning
the air regulator knob (E) either clockwise or
counterclockwise. The maximum tool speed can
be obtained when the concave line on the knob
(E) is pointing at horizontal (See Figure 2).
When first making contact with the surface you
intend to sand, ensure the speed is set to the
lowest setting. Gradually increase the power/speed
as needed for your particular sanding application(s)
instead of using too much power/speed from the
start.
7
1
2
12