Removing / Replacing The Throat Plate; Adjustments - Craftsman 315.272350 Owner's Manual

REMOVING / REPLACING THE THROAT
PLATE
See Figure 43.
WARNING:
Make sure the switch is off, the
switch key is removed, and your saw is
unplugged. Failure to do so could result in
accidental starting, resulting in serious personal
injury.
To remove the throat plate, first loosen the screw in
the throat plate with a phillips screwdriver and lift
the front end. Pull it out toward the front of the saw.
To re-install the throat plate, place it in the opening.
Push it toward the rear of saw base to engage the
spring clip.
Note: The keyslot in the throat plate will drop over the
screw.
Check that the throat plate is even with the table
top. If not, adjust the four set screws with a 2 mm
hex key. See the procedure in the Assembly
section.
Securely tighten throat plate screw. Do not allow the
throat plate to bow up above the table surface.
® TABLE SAW 315.272350

ADJUSTMENTS

THROAT PLATE
KEY SLOT
SCREW
32
SET SCREWS
SPRING CLIP
TABLE
TOP
Fig. 43