Install Back Molded Brick Panel - Herringbone; Install Side Molded Brick Panel - Herringbone - Heatilator BIR42-B Installation Manual

D. Install Back Molded Brick Panel - Herring-
bone
• Remove screen rods.
• Remove smokeshield.
• Refer to Figure 8.2.
• Set the grate brackets in place, 26.5 in. (673 mm) center
to center.
• Install the lower back panel. Center from side to side.
• Install two T-brackets stem down into mortar line to hold
lower back in position. Do not tighten.
• Install upper back panel. Position bottom of panel behind
the previously installed T-brackets.
• Install three T-brackets stem side up into mortar line, do
not tighten
• Install two Z-brackets in the mortar lines across the top.
Tighten these and all previously installed brackets.
LH Herringbone Refractory
Figure 8.2 Herringbone Molded Brick Panel
Heatilator • Birmingham 42-B Installation Manual • 4059-715 • Rev C • 2/14/13
E. Install Side Molded Brick Panel - Herring-
bone
• If a gas line is to be installed, remove the knockouts in
the inner fi rebox and in the outer shell on the side of
your choice. Refer to dimension drawings for location
of knockouts and Section 7.I. for gas provisions.
• Install side panel, tapered edge to the front. Align the
front edge with the front of the column (or butted to the
surround if installed).
• Install two Z-brackets in the mortar lines across the top.
Tighten these and all previously installed brackets.
• Install second side panel following the steps above.
• Replace the smokeshield.
Hearth
Back Herringbone Refractory
Refractory clip
35