Projecting An Image (Basic Operation); Turning On The Projector - NEC VT37 User Manual

3. Projecting an Image (Basic Operation)

This section describes how to turn on the projector and to project a picture onto the screen.

Turning on the Projector

NOTE:
• The projector has two power switches: a main power switch and a POWER (ON/STAND BY) button (POWER ON and OFF on the
remote control).
• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off ( )
position. Failure to do so may cause damage to the projector.
1. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
• The POWER indicator will light orange.
See the Power Indicator section on page
details.
2. Press the POWER (ON/STAND BY) button on the
projector cabinet or the POWER ON button on the
remote control for a minimum of 2 seconds. The
POWER indicator will turn to green and the projector
will become ready to use.
After you turn on your projector, ensure that the
computer or video source is turned on and that your
lens cap is removed.
NOTE: When no signal is available, a blue, black or logo screen is
displayed.
When the projector displays a blue or a black screen (not logo),
the Eco mode will be automatically selected in "Lamp Mode."
NOTE: If you turn on the projector immediately after the lamp is
turned off or when the temperature is high, the fans runs without
displaying an image for some time and then the projector will
display the image.
49 for more
Steady orange light
See page
19
LAMP
STATUS
POWER
LAMP
STATUS
POWER
SELECT
ON/STAND BY
OFF ON
POWER
MAGNIFY PIC-MUTE PAGE
UP
DOWN
MENU
Standby Blinking
LAMP LAMP
STATUS STATUS
POWER
POWER
Blinking green
light
49 for more details.
A C IN
VIDEO S-VIDEO COMPUTER
AUTO
ADJ.
Power On
LAMP
STATUS
POWER
Steady green
light