Sub Zone Playback - Teac AG-980 Owner's Manual

SUB ZONE PLAYBACK

• This function allows enjoying one source in the main room and playing another in a different room at the same time.
• Even when this receiver enters the standby mode, in such a case that "R2" is dimly lit, meaning only the SUB ZONE circuitry
operates, the SUB ZONE source can be played independently. Therefore, when you do not use the SUB ZONE function, turn
off the SUB ZONE function to save electricity.
• To enjoy SUB ZONE source, turn on the SUB ZONE function and adjust the SUB ZONE settings as below.
.
1
Enter the SUB ZONE mode.
.
2
Turn on the SUB ZONE mode.
.
3
Select the desired SUB ZONE speakers.
• "R2 > ~ " is displayed for several seconds.
• Each time this button is pressed, the mode is changed to
the SUB ZONE mode ("R2 > ~") or the main mode (main
input display).
• When "R2 > ~" is not displayed, press this button again.
∑Note :
• Only while displaying the SUB ZONE mode, you can set the
SUB ZONE mode.
• Each time the "ON/STANDBY" button on the front panel is
pressed, the SUB ZONE mode changes as follows :
R2 > OFF : SUB ZONE off mode ("R2" turns off)
R2 > input display : SUB ZONE on mode ("R2" lights up)
• On the remote control, press the ON button to turn on the
SUB ZONE mode or press the STANDBY button to turn it
off.
∑Note :
• Only while displaying the SUB ZONE on mode, you can
adjust the SUB ZONE settings.
• Press the button to select the desired input source.
∑Note :
• Only when the SUB ZONE mode is set to on, the speakers
C or/and D can be used as SUB ZONE speakers.
21