Gear Shift Adjustment; Break-In; Starting And Operating Instructions - Joyner JNSZ650UV4S Owner's Manual

- Pull the park brake lever up so that the unit can engage park brake.
- To release the unit, press button on front end of parking lever then push the parking
lever to the bottom.
- Adjust the parking cable if necessary.

Gear Shift Adjustment

Before operate the vehicle, check the shift
lever as to change gearshift from 1 to 4 and
reverse smoothly.
The shift lever should be vertical when the
gear is in neutral .If not ,adjust the shift cable
and then Tighten the nuts of the shift cable

Break-in

The first month is most important in the life of your vehicle. Proper operation during
this break-in period will help assure maximum life and performance from your new
vehicle. The following guidelines explain proper break-in procedures.
1. After the engine starts, the engine is not allowed in high speed in the neutral
gearshift.
2. Drive vehicle from stop to low speed slowly.
3. Avoid braking strongly.
4. Do not exceed the vehicle speed on the below schedule
The speed of vehicle
Max speed in each gear

Starting and Operating Instructions

- Before starting the engine, be sure that the driver is seated properly in the UV650-4S
and tighten the seat belts.
- Testing the UV650-4S in a open place at the beginning to learn how to start, turn and
stop.
- Operate the UV650-4S slowly until you are familiar with it.
- The turning radius of this UV650-4S is small and agile, so the centrifugal force is
very high when turning at high speed. Slow down to a more controllable speed when
turning to prevent the UV650-4S from rolling over.
The first 1000 km
1st Gear
2nd Gear
3rd Gear
4th Gear
15km/h
25km/h
35km/h
55km/h
44