Software Installation - Velleman CAMIP4N User Manual

• Use the mounting bracket [7] to determine the location of the mounting holes. Drill the holes and
secure the bracket [7] using 3 screws.
• Attach the camera to the mounting bracket [7] with the camera bolt [5]. The camera has two
mounting holes, make sure to use the one that provides an upright image. This depends on the type
of mounting (ceiling or wall). When using the top hole (ceiling mounting or camera hanging on
bracket), place the sunshield [4] over the camera bolt [5] before mounting the camera. When using
the bottom hole (camera resting on top of the bracket), mount the sunshield [4] by using the top
hole and the included bolt and washer.
• Point the camera towards the zone of interest and tighten the position bolt [6].
• Connect the power connector [C] to the 12VDC power supply (incl.).
• Connect the BNC connector [B] to a monitor (not incl.) and/or to a computer network via the RJ45
connector [A]. If in doubt, contact your local network service provider.

6. Software installation

• The camera comes with a CD-ROM containing the CamView software. Insert the CDROM into a
suitable computer (refer to §9 - Technical specifications).
• Locate the CamViewInstaller-V2.03.xx.exe (xx is de current version number) and double click on
it. The installation starts and the welcome screen is shown.
• Click Next >. The Select Packages screen is shown.
• If Framework 2.0 is already installed on the computer, uncheck the checkbox. If in doubt, leave it
checked, the computer will check.
• Click Next >. The Installation Folder screen is shown.
• Select the desired location with the Change... button and click Next >. The Shortcut Folder
window appears.
• Select the desired location from the dropdown menu, select whether to make shortcuts available
for all users or not and click Next >. The Ready to Install window appears.
21/01/2010
CAMIP4N
4
Rev. 01
©Velleman nv