Center Of Gravity; Transmitter Control Identification - E-flight Blade SR RTF Airframe Instruction Manual

Center of Gravity

Once you have properly installed and secured the battery, check the helicopter's center of gravity. With the canopy
installed, lift the helicopter by the flybar with the flybar positioned perpendicular to the tail boom. Move the battery
forward or rearward as required to achieve a slightly nose down or perfectly level helicopter position. You should always
check the CG of your Blade SR before flying, especially if you are switching between different sizes and types of battery
packs.
Level or Slightly
Downward Angle
Support by Flybar
12

Transmitter Control Identification

Note: Before each flight ALWAYS turn the transmitter on before connecting the flight battery to the 2-in-1 unit.
After each flight, you should always disconnect the flight battery from the 2-in-1 unit before powering the
transmitter off.
Mode 2
Rudder/Throttle
Functions
Rudder Trim
Throttle Trim
Mode 1
Rudder/Elevator
Functions
Rudder Trim
Elevator Trim
Aileron/Elevator
Functions
Aileron Trim
Elevator Trim
Aileron/Throttle
Functions
Aileron Trim
Throttle Trim
13