E-flight Blade SR RTF Airframe Instruction Manual page 12

If at any time during the test the controls do not respond properly, double-check the positions of the dip switches
located under the door on the bottom left front of the transmitter. These dip switches set the transmitter programming
for functions such as servo reversing, model type and various forms of mixing. Each switch should be set in the
position as shown for proper control of the Blade SR.
22
For added reference, the following are the functions and available settings for each dip switch (default settings for the
Blade SR are underlined):
Dip Switch 1*
Up – Channel 1/Throttle channel reversed
Down – Channel 1/Throttle channel normal
*For safety, channel 1/throttle channel reversing can only be changed when the transmitter is powered off. All
other dip switch positions/functions can be changed while the transmitter is powered on.
Dip Switch 2
Up – Channel 2/Aileron channel reversed
Down – Channel 2/Aileron channel normal
Dip Switch 3
Up – Channel 3/Elevator channel reversed
Down – Channel 3/Elevator channel normal
Dip Switch 4
Up – Channel 4/Rudder channel reversed
Down – Channel 4/Rudder channel normal
Dip Switch 5
Up – Channel 5/Gear channel reversed
Down – Channel 5/Gear channel normal
Dip Switch 6
Up – Channel 6/Pitch channel reversed
Down – Channel 6/Pitch channel normal
Dip Switch 7
Up – H elicopter Mode (Channel 6 becomes
pitch channel)
Down – A irplane Mode (Channel 6 becomes an extra aileron channel)
23