Blade Sr Rtf Contents; Needed To Complete; Preparing For The First Flight; Flying Checklist - E-flight Blade SR RTF Airframe Instruction Manual

Blade SR RTF Contents

Item Description
Not Available Separately . . . . . . . . . . . . . . Blade SR RTF Airframe
EFLH1057 . . . . . . . . . . . . . . . . . . . . . . . . HP6DSM 6-Channel Transmitter, 2.4GHz DSM2: BSR
EFLB0997 . . . . . . . . . . . . . . . . . . . . . . . . 1000mAh 3S 11.1V 15C Li-Po, 20AWG JST/Balance
EFLC3105 . . . . . . . . . . . . . . . . . . . . . . . . 3S 11.1V Li-Po Balancing Charger, 0.8A
EFLC4000 . . . . . . . . . . . . . . . . . . . . . . . . AC to 12V DC, 1.5- Amp Power Supply
EFLH1519 . . . . . . . . . . . . . . . . . . . . . . . . Micro Helicopter Main Blade Holder: BSR
EFLH1129 . . . . . . . . . . . . . . . . . . . . . . . . Mounting Accessories & Wrench
EFLH1528 . . . . . . . . . . . . . . . . . . . . . . . . Hook and Loop Material
EFLH1444 . . . . . . . . . . . . . . . . . . . . . . . . Hook and Loop Strap
FUG4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 AA Batteries

Needed to Complete

No additional equipment is required to complete your Blade SR.
4

Preparing for the First Flight

Please note this checklist is not intended to be a replacement for the content of this instruction manual. Although it can
be used as a quick start guide, we strongly suggest reading through this manual completely before proceeding.
• Remove and inspect contents
• Begin charging the flight battery (see charging procedures on following pages)
• Install the 4 included AA batteries in the transmitter
• Install the flight battery in the helicopter (once it has been fully charged)
• Check the Center of Gravity of the helicopter (see page 12)
• Test the controls (see page 14)
• Install the optional Training Gear Set (EFLH1527; strongly recommended if this is your first collective-pitch
equipped helicopter model)
• Familiarize yourself with the controls
• Find a suitable area for flying
Please note this checklist is not intended to be a replacement for the content of this instruction manual. Although it can
be used as a quick start guide, we strongly suggest reading through this manual completely before proceeding.
q Always turn the transmitter on first
q Plug the flight battery into the 2-in-1 control unit
q Allow the 2-in-1 control unit and gyro to arm and initialize properly
q Fly the model
q Land the model
q Unplug the flight battery from the 2-in-1 control unit
q Always turn the transmitter off last

Flying Checklist

5