E-flight Blade SR RTF Airframe Instruction Manual page 20

You can use the rudder trim to help keep the nose of the helicopter from rotating to the left or right when in hover
with no rudder stick input. For example, if the nose of the helicopter drifts to the right when in hover, add left rudder
trim until the nose stays as close to straight as possible. Also note that further adjustments to the rudder trim can be
made using the main motor proportional mix trimmer pot as outlined in the "Tail Rotor Proportional Mix Trimmer Pot
Adjustment" section of the manual.
The right-hand stick controls both elevator (pitch fore/aft) and aileron (roll). Pushing the stick forward will pitch the nose
of the helicopter downward, allowing the helicopter to be flown forward.
Mode 2
Heli Moves Forward
Mode 1
38
Pulling the stick backward will pitch the tail of the helicopter downward, allowing the helicopter to be flown backward.
Mode 2
The elevator trim can be used to help keep the helicopter from drifting forward or backward when in hover with no
elevator stick input. For example, if the helicopter drifts forward when in hover, pull the elevator trim downward until the
helicopter hovers as level as possible with no forward drifting.
Mode 1
Heli Moves Backward
39