Operation; General Controls - NEC MT 1020 User Manual

3 O P E R A T I O N
This section describes how to select a computer or video source and how to adjust
the picture and sound.
General Controls Before you turn on your MultiSync MT1020/MT820 LCD
Projector, ensure that the computer or video source is turned on and that your lens
cap is removed.
1. Turn On The LCD Projector The main power switch is on the back panel of
the MultiSync MT1020/MT820 LCD Projector. By turning this switch on, the
projector will go into its standby mode and the power light will glow amber.
Only after you press the "On" button on the remote control or projector cabinet
will the power light turn to green and the projector become ready to use.
NOTE: To turn the LCD projector on and off with just the back panel switch, use the
menu and enable the "auto start" feature. (See page 57. )
2. Select The Computer Or Video Source Press the "Video" (VCR, document
camera, or laser disc player), "S-video", "RGB 1" or "RGB 2" (computer)
button on the remote control to display the image. Or press the "Menu" button
on the cabinet and use the icons to select your video source: "Video", "S-
Video", "RGB 1" or "RGB 2."
3. Adjust The Image Size Press the "Zoom" button (+) or (-) on the remote control or
projector cabinet to make the image larger or smaller.
4. Focus Press the "Focus" button (+) or (-) on the remote control or projector cabinet to
focus the image.
5. Turning Off The Projector First press the "off" button on the remote control or the
projector cabinet. The power light will glow amber. Then turn off the main power
switch on the back panel. The power light will go out.
IMPORTANT:
• The LCD projector should be unplugged if it will not to be used for an extended
period.
• To turn off the image briefly (five minutes or less), use the "Picture Mute" button
instead of turning the projector off and on.
• The LCD projector will display a black, blue, or loop image if no input signal is
present.
• Do not turn the LCD projector off and then immediately back on. The projector needs
to cool for a minute before it can be restarted.

OPERATION

47
48