Connecting Your Pc Or Macintosh Computer - NEC MT 1020 User Manual

Connecting Your PC Or Macintosh Computer

Connecting your PC or Macintosh computer to your MultiSync MT820 (SVGA)/
MT1020 (XGA) LCD Projector will enable you to project your computer's screen
image for an impressive presentation. All of these following display standards are
supported:
VGA 640 480 for graphics
VGA 640 350 for graphics
VGA 720 350 for text
XGA 1024 768*
Macintosh at 640 480
* indicates that this resolution is supported by MT1020 only.
To connect to a PC, Macintosh or computer equipped with an XGA/SVGA/VGA
adapter or compatible graphics adapter, simply:
1. Turn off the power to your LCD projector and computer.
2. If your PC does not support XGA/SVGA/VGA you will need to install an XGA/
SVGA/VGA graphics board. Consult your computer's owner's manual for your
XGA/SVGA/VGA configuration. If you need to install a new board, see the manual
that comes with your new graphics board for installation instructions.
3. Use the MultiCable that's supplied to connect your PC or Macintosh computer to the
LCD projector. For a PC, use the smaller 15-pin connector on the cable to connect to
your computer's video port; use the larger 15-pin connector on the cable to connect
to the projector's RGB 1 input. For Macintosh, use the larger 15-pin connector on the
cable to connect to your computer's video port; use the smaller 15-pin connector on
the cable to connect to the projector's RGB 2 input. (You can also use your own
video cable if you wish. For a PC cable, use the smaller 15-pin connector RGB 2 on
the projector. For a Macintosh cable, use the larger 15-pin connector RGB 1 on the
projector.)
4. Turn on the LCD projector and the computer.
5. If the projector goes blank after a period of inactivity, it may be caused by a screen
saver installed on the computer you've connected to the projector.
NOTE: Refer to your computer's owner's manual for more information about your
computer's video output requirements and any special identification or configuring your
projector's image and monitor may require.
INSTALLATION
VGA 640 400 for graphics
VGA 720 400 for text
SVGA 800 600
Macintosh at 1024 768*
Macintosh at 832 624
37
38