Maintenance
4.
Clean the filter (located on the end of the
suction pipe) in a suitable cleaning sol-
vent. Allow the filter to dry.
5.
Replace the gasket with a new one. Re-
install the fuel joint assembly and tighten
the screws firmly.
EMU29312
Inspecting and replacing anode(s)
Yamaha outboard motors are protected from
corrosion by sacrificial anodes. Inspect the
external anodes periodically. Remove scales
from the surfaces of the anodes. Consult a
Yamaha dealer for replacement of external
anodes.
ECM00720
NOTICE
Do not paint anodes, as this would render
them ineffective.
TIP:
Inspect ground leads attached to external
anodes on equipped models. Consult a
Yamaha dealer for inspection and replace-
ment of internal anodes attached to the pow-
er unit.
61
ZMU02324
EMU29322
Checking battery (for electric start
models)
EWM01900
WARNING
Battery electrolytic fluid is poisonous
and caustic, and batteries generate ex-
plosive hydrogen gas. When working
near the battery:
Wear protective eye gear and rubber
●
gloves.
Do not smoke or bring any other source
●
of ignition near the battery.
Refer to page 11 for detailed safety infor-
mation about batteries.
The procedure for checking the battery var-
ies for different batteries. This procedure
contains typical checks that apply to many
batteries, but you should always refer to the
battery manufacturer's instructions.
ECM01920
NOTICE
A poorly maintained battery will quickly
deteriorate.
1.
Check the electrolyte level.
ZMU02325